Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Setting up Audio and Video Information
OL-29015-01
187
Setting up Cue Tones
1 From the user interface of the D9824, choose Audio & Video > Cueing > Cue
Tone. The Cue Tone page is displayed.
2 The Sequence Number lists the tone sequences. The receiver supports up to 16
tone sequences. You can configure the state, tones, mode, and delay for each tone
sequence.
sequence.
3 Choose the current state of the tone sequence from the Sequence State drop-
down list (Enabled or Disabled). If disabled, no cue tone is output.
4 In the Sequence Tones field, set the three digit tone sequence (1 to 999).
5 Choose the tone from the Sequence Mode drop-down list.
5 Choose the tone from the Sequence Mode drop-down list.
Choose * for start tone, # for the end tone, and */# for the start and end tones.
The end tone is signaled after waiting the time specified in Sequence Delay.
The end tone is signaled after waiting the time specified in Sequence Delay.
6 If the Sequence Mode was set to */# (Start/Stop), enter the sequence delay, in
seconds, between the start and stop sequences in the Sequence Delay field. You
can enter a value in the range from 1 to 255. The default is 30.
can enter a value in the range from 1 to 255. The default is 30.
7 Click Apply.