Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Chapter 5 Web GUI Setup and Monitoring
220
OL-29015-01
The CDT is different from the other tables listed because the CDT is referred to
within the PMT, rather than outside the PMT. Check the Block CDT Output
check box to override the DPM PID map configuration for CDT PIDs and to
always drop all CDTs. Otherwise, uncheck the Block CDT Output check box to
permit the output of CDTs following the configured DPM PID map
configuration and all other DPM constraints.
within the PMT, rather than outside the PMT. Check the Block CDT Output
check box to override the DPM PID map configuration for CDT PIDs and to
always drop all CDTs. Otherwise, uncheck the Block CDT Output check box to
permit the output of CDTs following the configured DPM PID map
configuration and all other DPM constraints.
11 Click OK.
12 Click Apply.
13 Click Copy to ASI to copy all the DPM data from the MPEG over IP output to
12 Click Apply.
13 Click Copy to ASI to copy all the DPM data from the MPEG over IP output to
the ASI output.
Viewing the MPEG Output Transport Status
From the user interface of the D9824, choose Transport Stream > Output Transport
Status under MPEG over IP Output. The PID Output Status page is displayed.
Status under MPEG over IP Output. The PID Output Status page is displayed.
The Program Entry - Referenced PIDs table displays the specified PE ES PIDs
information on the output.
information on the output.
The Output Channel and PID Conflicts table displays a list of conflicts when the
DPM alarm is active.
DPM alarm is active.