Cisco Cisco D9824 Advanced Multi Decryption Receiver 설치 가이드
Configuring System Settings
OL-29015-01
239
5 The Alarm Setup area displays a list of the alarm/fault messages. For more
information on alarm messages, refer to D9824 Alarm Messages (on page 264).
6 From the Enable/Disable drop-down list, choose Yes to report the alarm
message. Choose No to disable the alarm and the Relay and Trap settings are
ignored.
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.
ignored.
Note: Enable/Disable must be set to Yes for the Relay and Trap settings to be
functional.
7 If current alarm is enabled, from the Trap drop-down list, choose Yes to send the
SNMP trap message when the alarm is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
8 If current alarm is enabled, from the Relay drop-down list, choose Yes to trigger
the rear panel alarm when the alarm is set or cleared.
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
Note: No is a read only value that indicates the setting is Yes, but is currently
being suppressed because the alarm is disabled (Enb is set to No).
9 Click Apply.
To Set Up Warnings
1 From the Alarm Setup page, click the Warning Setup link at the bottom left hand
1 From the Alarm Setup page, click the Warning Setup link at the bottom left hand
corner of the page. The Warning Setup page is displayed.
2 Check the Enable Alarm/Warning Front Panel Reminder check box for the
warning to flash on the LCD display for a two-second interval every 10 seconds.
The warning will continue to flash periodically until it is either cleared or the
Enable Alarm/Warning Front Panel Reminder is de-selected.
The warning will continue to flash periodically until it is either cleared or the
Enable Alarm/Warning Front Panel Reminder is de-selected.
3 The Warning Setup area displays a list of the warning messages. For more
information on warning messages, refer to D9824 Alarm Messages (on page 264).