Cisco Headend System Release 2.5 사용자 가이드
4004831 Rev B
Releasing Bandwidth on the GoQAM
4-3
Block a Program to Release Bandwidth on the GoQAM,
Continued
10. In the Session Setup
window, click the Input
Device arrow and select the
type of device (the MPEG
source) that will be
providing the service
content (for example, an IRT)
and then click Next.
Note: You defined the
Note: You defined the
MPEG source when you set
up your network.
11. In the Output Selection
Policy window, select the
appropriate output TSID
from the list and click Next.
12. In the Wrap-up window,
complete the following
fields:
•
•
MPEG Program Number
Input—Type the MPEG
program number used in
the clear input stream.
•
MPEG Program Number
Incumbent— Type the
MPEG program number
used in the encrypted
input stream.
•
Bandwidth—Type the
amount of bandwidth (in
Mbps) that the system
should allow for this
service. Your content
service provider usually
defines this value.
Requirements vary from
system to system.
•
Encryption percentage—Type 99 for the encryption percentage in both the
Audio and Video fields.
Continued on next page