Cisco Headend System Release 2.7
Chapter 2 DNCS Configuration for Distributed BFS
26
4017541 Rev B
Finding the Direct ASI Program Numbers
1 On the DNCS Administrative Console, click the Application Interface Modules
1 On the DNCS Administrative Console, click the Application Interface Modules
tab.
2 Click BFS Admin. The Site DNCS BFS Administration window opens.
3 On the Hosts tab, double-click dncsatm. The Set Up BFS Host window opens.
3 On the Hosts tab, double-click dncsatm. The Set Up BFS Host window opens.
4 Click PAT Configuration. The Inband Data PAT window opens.
5 From the Inband Data PAT table, note the program numbers for sessions 2
through 22 (or 24 if you are using SDV) and the OSM session on the Worksheet
at the end of this chapter.
at the end of this chapter.
6 Click Close in the Inband Data PAT window.
7 Click Cancel in the BFS Host window.
8 Close the DNCS BFS Administration window from the File menu.
9 Go to Setting Up Source Definitions and CF Sessions, next in this section, to set
7 Click Cancel in the BFS Host window.
8 Close the DNCS BFS Administration window from the File menu.
9 Go to Setting Up Source Definitions and CF Sessions, next in this section, to set
up the source definition and build the CF sessions for the BFS QAMs.