Cisco Headend System Release 2.7
Chapter 3 Enabling CVT Downloads on the DNCS
48
4017541 Rev B
Gather Information for Your OSM Configuration
File
File
Gather the following information for each data QAM in your system. Record this
information in the worksheet on the following page.
information in the worksheet on the following page.
Output TSID—To find the numeric output transport stream ID for the QAM,
open the Set Up QAM window by clicking QAM from the Network Element
Provisioning tab.
open the Set Up QAM window by clicking QAM from the Network Element
Provisioning tab.
Headend ID—Write down the exact headend ID for the "real" headend QAM
that is included in your system. This Headend ID will be repeated in each of the
three record types you enter in the osmAutoMux.cfg file (QAM, HUB, and SESS
records).
Notes:
that is included in your system. This Headend ID will be repeated in each of the
three record types you enter in the osmAutoMux.cfg file (QAM, HUB, and SESS
records).
Notes:
If arbitrary QAMs are set up in your system, choose arbitrary numbers to
make tracking the configuration easier. This number does not have to match
the actual headend ID. Each QAM must have its own unique number.
make tracking the configuration easier. This number does not have to match
the actual headend ID. Each QAM must have its own unique number.
If real QAMs are set up in your system, you must enter the actual headend
ID for the headend device.
ID for the headend device.
Session MAC Address—Write down the 12-character HEX MAC address
without the colons (:). The session MAC Address is determined by the value that
was used when sessions were built.
without the colons (:). The session MAC Address is determined by the value that
was used when sessions were built.
Session ID—Session IDs range from 2 to 22. For the OSM session, the session ID
for the primary OSM session is 199. The session ID for the secondary OSM
session is 299.
for the primary OSM session is 199. The session ID for the secondary OSM
session is 299.
Hub ID—To find the numeric Hub ID, go to the Hub Summary window by
clicking Hub under the Element Provisioning tab.
clicking Hub under the Element Provisioning tab.