Cisco Headend System Release 2.5
Bootloader Error Codes for Multi-Segment-LED DHCTs
736107 Rev D
143
LED Message
Error Indication
CLr_
Displays while the flash sectors are being erased, before programming. The
received image's CRC was valid, and flash programming will begin soon.
dala
"Data move" save error. Either the NVM copy is too big to save (greater than 256
KB), the CRC of the data is invalid, or there is no data to save because a "data
move" has not been done on this DHCT.
Displayed by BSTRAP.IMG (xA2, xA3, xA3p, or xG2 protocols with "d" option).
Displayed by BSTRAP.IMG (xA2, xA3, xA3p, or xG2 protocols with "d" option).
Try again without the "d" option.
donE
Displayed by the BSTRAP.IMG when the upload is complete. Reset the DHCT to
re-gain control of it.
Er.00
MIPS bootloaders: Clock initialization error. The bootloader is unable to
initialize a system PLL.
SPARC bootloaders: Ethernet link initialization failed. Either the Ethernet
option board is not in the DHCT, is not properly seated in the connector, or the
board is defective. Displayed by BSTRAP.IMG (xA2, xA3, xA3p, or xG2
protocols).
Er.01
MIPS bootloaders: Error loading the "BootHi" portion of the bootloader.
SPARC bootloaders: Transfer error during download. XLD has retransmitted
the same packet 3 times, but the DHCT cannot validate the packet. Check all
serial or Ethernet connections and try again. Displayed by BSTRAP.IMG (xA2,
xA3, xA3p, or xG2 protocols).
Er.02
MIPS bootloaders: A memory test of the RAM reserved for the "Boothi"
portion of the bootloader failed.
SPARC bootloaders: The image would not fit in NVM or the image CVC
failed. Displayed by BSTRAP.IMG (xA2, xA3, xA3p, or xG2 protocols).
Er.03
Signature error.
Er.05
During an upload of memory contents to the PC, the PC failed to acknowledge
that it received a data packet from the DHCT within the 3-second timeout limit.
Correct the problem on the PC, reset the DHCT, and try again.
Displayed by BSTRAP.IMG (c55 command with xA2, xA3, xA3p, or xG2
Displayed by BSTRAP.IMG (c55 command with xA2, xA3, xA3p, or xG2
protocols).
Er.06
Transfer error during upload. The DHCT has transmitted the packet 3 times, but
XLD cannot validate the packet. Check all connections and try again.
Displayed by BSTRAP.IMG (c55 command with xA2, xA3, xA3p, or xG2
Displayed by BSTRAP.IMG (c55 command with xA2, xA3, xA3p, or xG2
protocols).
Er.07
Disk access not supported. The DHCT does not support transfers to disk
because its disk drive is either missing or not connected. Displayed by
BSTRAP.IMG (c57 command with xA2, xA3, xA3p, or xG2 protocols).
Command not supported. Only RAM-resident or disk-based bootloaders
support this command. Displayed by BSTRAP.IMG or BSTR60.IMG.