Cisco Headend System Release 2.7 사용자 가이드
Chapter 3 Delete BFS Sources
44
4001182 Rev B
12 Realign the PAT table entries in ascending order (optional).
Note: It is not necessary for the PAT table entries to be in ascending order for the
system to operate properly. It is simply an option for sites that want maintain an
orderly PAT table.
a On a sheet of paper, write down every entry in the BIG PAT or Inband Data
system to operate properly. It is simply an option for sites that want maintain an
orderly PAT table.
a On a sheet of paper, write down every entry in the BIG PAT or Inband Data
PAT window with a session number greater than the session number for the
data carousel you deleted.
data carousel you deleted.
Important! Make sure to record the Session MAC address and the session
number for each entry.
number for each entry.
b Follow these instructions to delete each entry with a session number greater
one you deleted.
i Highlight an out-of-order entry and click Delete Entry. A confirmation
window opens.
ii Click OK. The system deletes the out-of-order entry.
Note: Ignore any BFS restart messages that may appear. You will stop
and restart the BFS processes later in this chapter.
and restart the BFS processes later in this chapter.
c Click New Entry. The BIG PAT Setup window opens.
d On the BIG PAT Setup window, type the Session MAC Address and Session
d On the BIG PAT Setup window, type the Session MAC Address and Session
Number for the next out-of-order entry that you recorded on your sheet of
paper from step 12.
paper from step 12.
Note: The Program Number and PMT PID fields are already filled in. Use the
default data for these entries.
default data for these entries.
e Click Save. The system saves the just-added entry in proper ascending order.
f Repeat steps c through e for each out-of-order entry that you recorded on the
f Repeat steps c through e for each out-of-order entry that you recorded on the
sheet of paper.
Note: When you have completed this procedure, all Program Numbers and
PMT PIDs will be in ascending order.
PMT PIDs will be in ascending order.
13 Choose one of the following options:
Systems with a BIG: From the Set Up BIG window, click Save and click
Cancel.
Cancel.
Systems with an ASI: From the Set Up BIG window, click Save.
14 Choose one of the following options:
Systems with a BIG: From the BIG List window, click File and select Close.
Systems with an ASI: From the BFS Administration window, click File and
select Close.
select Close.
15 Go to Stop the BFS Server Processes (on page 45).