Cisco Model D-PCG1000 PowerKEY CAS Gateway 사용자 가이드
7-2
Setting Up a Virtual Channel Service
749606 Rev D
Configure the VCS Broadcast File System (BFS)
Introduction
Typically during a system upgrade, the installer configures the BFS source ID for the
virtual channel server on your system. However, if this procedure was not
performed at the time of upgrade, use the following procedures to check or
configure a BFS server for the virtual channel service.
In earlier releases of the Application Server, virtual channel files could only exist on
In earlier releases of the Application Server, virtual channel files could only exist on
BFS Source ID 2 (inband) with other OSM files such as PowerTV
®
Note: Although you can move the files more than once, it should not be necessary.
and SARA ROM.
With recent modifications to the arrangement of alternating BFS files, small virtual
channel server files now circulate very slowly, and leave the virtual channels
practically useless. To resolve this issue, you must move the virtual channel files to a
new source. Doing so allows the BFS to update the information it sends to the
DHCTs and the virtual channels can then appear faster.
To move virtual channel files you must complete the following tasks.
1. Create a new digital source and the source definition.
2. Add the source to the Selected Sources List on the BFS Server.
3. Configure the new BFS server source ID on the virtual channel server.
1. Create a new digital source and the source definition.
2. Add the source to the Selected Sources List on the BFS Server.
3. Configure the new BFS server source ID on the virtual channel server.