Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split 설치 가이드
Chapter 5 Using the Web Interface
48
4037424 Rev A
1 If the GS7000 Configuration Data page is not the active page, click the GS7000
button in the left pane. The GS7000 Configuration Data page appears as shown
in the following example.
in the following example.
2 Set the appropriate configuration options (see table below), and then click the
Apply button. A login dialog appears if the login process had not been
performed previously during the current session.
performed previously during the current session.
3 In the login dialog, enter the correct user name and password, and then click
OK.
The following table lists the configuration options available on the GS7000
Configuration Data page.
Configuration Data page.
Component
Description
Node Type
Sets the GS7000 device type to one of the following:
deviceGS7000
deviceGS7000opticalHubNode
Forward Configuration The forward configuration of the node.
oneX/twoXFwdSeg - Forward RF signal for all ports
comes from one or two optical receivers.
comes from one or two optical receivers.
fourXFwdSeg - Forward RF signal for each port comes
from separate optical receivers.
from separate optical receivers.
threeXRx1-2-4FwdSeg - Forward RF signal for each port
comes from one of three separate optical receivers. The
three receivers are Rx1, 2 and 4; Rx3 is not powered on.
comes from one of three separate optical receivers. The
three receivers are Rx1, 2 and 4; Rx3 is not powered on.
threeXRx1-3-4FwdSeg - Forward RF signal for each port
comes from one of three separate optical receivers. The
three receivers are Rx1, 3 and 4; Rx2 is not powered on.
comes from one of three separate optical receivers. The
three receivers are Rx1, 3 and 4; Rx2 is not powered on.