Cisco Model GS7000 4-Port Node 1 GHz with 55 70 Split 설치 가이드
Chapter 3 Configuration
22
4024769 Rev A
Menu Item Configuration Parameter Description/Values
9 Copy
9 Copy
Parameters
To Product
Setting 1
Setting 2
Setting 3
Setting 4
Setting 4
Setting 6
Setting 7
Setting 8
Setting 9
Setting 2
Setting 3
Setting 4
Setting 4
Setting 6
Setting 7
Setting 8
Setting 9
Description: Read/Write configuration
parameter. Copy up to nine node configuration
settings to a LCM in another node.
parameter. Copy up to nine node configuration
settings to a LCM in another node.
Values: Abort, Restore
9 Copy
Parameters
Restore Default
Description: Allows the restoration of the
default settings, which is for a fully populated
node with two AC lines, two power supplies,
four receivers, and four transmitters installed.
default settings, which is for a fully populated
node with two AC lines, two power supplies,
four receivers, and four transmitters installed.
Values: Abort, Restore
Configuring the LCM
The LCM can be configured using two different methods, as follows:
Using the Auto-Setup button
Using a handheld programming terminal
The following sections describe these procedures in detail.
Configuring the LCM Using the Auto-Setup Button
Important: In order for a module to be detected and counted as "installed", it must
be functioning properly at the time the Auto-Setup button is pressed. This includes
proper optical levels being fed to the receivers.
be functioning properly at the time the Auto-Setup button is pressed. This includes
proper optical levels being fed to the receivers.
Complete the following steps to configure the LCM using the Auto-Setup button.
1 Connect power to the node.
2 Connect optical fibers to all installed receivers.
3 Press and release the Auto-Setup button on the LCM.
1 Connect power to the node.
2 Connect optical fibers to all installed receivers.
3 Press and release the Auto-Setup button on the LCM.