Cisco Headend System Release 2.7 설치 가이드
Chapter 2 Installing the Alarm Manager Software
50
78-745262-01Rev C
8 Type sh EMS_Server_#.#.#.#.bin > /tmp/install.out 2>&1 and then press
Enter.
Notes:
Notes:
Substitute the actual numbers used in the filename for #.#.#.#.
This command may take several minutes to run if you are installing the
software on an Ultra2 server.
Important: After typing sh EMS_Server_#.#.#.#.bin, you may see the following
error message:
The specified scrollbar value is greater than the maximum scrollbar value
The specified scrollbar value is greater than the maximum scrollbar value
minus the scrollbar slider size.
You can ignore this error. The error has no impact upon the installation process.
Results:
You can ignore this error. The error has no impact upon the installation process.
Results:
The message Preparing to install … appears.
The Introduction window opens.
9 Read the messages on the Introduction window and then click Next. The
Software License Agreement window opens.
10 On the Software License Agreement window, select the I accept the terms of the
License Agreement option, and then click Next. The Choose Install Folder
window opens.
11 In the Where Would You Like to Install? text box, type the name of the directory
into which you want to install the Alarm Manager server software.
Note: The default directory is /EMS. Our engineers, however, recommend that
Note: The default directory is /EMS. Our engineers, however, recommend that
you install the Alarm Manager software into the /export/home directory of the
Alarm Manager server.
Important: If this is an upgrade, rather than the initial installation, you must
Important: If this is an upgrade, rather than the initial installation, you must
install the upgraded software into the directory where you installed the previous
version of Alarm Manager server software.
12 In a new xterm window, type df -k and then press Enter to verify that you have
sufficient space in the directory in which you want to install the Alarm Manager
server software.
Notes:
Notes:
You need 145 MB plus an additional 10 MB for each DNCS system that you
plan to monitor.
If you need more space than what is available in the directory you have
chosen, try these suggestions:
–
–
Delete unneeded files from the directory you have chosen.
–
Select another directory.
–
Call Cisco Services for assistance.