Cisco Headend Digital Broadband Delivery System 설치 가이드
Network Configuration
78-4021167-01 Rev D
29
4 Change or add the RNCS hostname to the file that contains the name of the
RNCS. If other entries exist, separate this new entry from the other entries by
using the Tab key.
Note: The hostname should be the same hostname that you entered in step 10 of
Note: The hostname should be the same hostname that you entered in step 10 of
Install the RNCS Software (on page 11).
Example: If your RNCS hostname is lionn2, the file entry may look similar to this
Example: If your RNCS hostname is lionn2, the file entry may look similar to this
example when you are finished:
demo_on onipcshm on_hostname on_servername
demo_se seipcpip se_hostname sqlexec
lionnDbServer setlitcp lionn2 informixSE
5 Save and close the file.
Enabling the FTP Service on the RNCS
For security purposes, the FTP service is disabled after the installation. EAS
equipment typically uses the FTP method to place files on the RNCS. Follow these
instructions to determine whether you need to enable the FTP service on the RNCS.
1 Is the FTP service required on this system?
1 Is the FTP service required on this system?
If yes, continue with step 2.
If no, go to Enabling TFTP and bootp Services (on page 30).
2 As root user in an xterm window on the RNCS, type the following and press
Enter:
inetadm –e svc:/network/ftp:default
inetadm –e svc:/network/ftp:default
3 Type svcs ftp and press Enter to verify that the ftp service is running.
Example: If the ftp service is running, you should see output similar to the
following:
STATE
STIME
FMRI
online
15:08:44
svc:/network/ftp:default
4 Using a text editor add the following lines to the /export/home/dncs/.profile
file:
# Source the Local EAS Interface IP address
LOCAL_EAS_IP=[EAS Interface IP]; export LOCAL_EAS_IP
Note: Replace [EAS Interface IP] with the IP address of the local interface on the
# Source the Local EAS Interface IP address
LOCAL_EAS_IP=[EAS Interface IP]; export LOCAL_EAS_IP
Note: Replace [EAS Interface IP] with the IP address of the local interface on the
RNCS that will receive EAS messages. Do not type the brackets [ ] in the
command.
5 Save and close the file.