Cisco Headend Digital Broadband Delivery System 사용자 가이드
4-10
Front Panel Display Options
4002178 Rev C
Specify the Minimum Number of Digits to Display
for Channels on the Set-Top
Introduction
The Number of LED Digits option allows you to specify the minimum number of
digits to display for channels in the LED on the front panel of the set-top. This
setting determines whether the set-top adds leading zeroes for channels that use less
than the specified minimum number of LED digits. If the channel number is greater
than this number of digits you enter, the LED shows the full channel number.
For example, if you enter 3 for this option, the LED displays a minimum of three
For example, if you enter 3 for this option, the LED displays a minimum of three
numbers when you tune to a channel:
•
•
Channel 12 will display 012
•
Channel 456 will display 456
•
Channel 1234 will display 1234
Specifying the Minimum Number of Digits to Display on the LED of the Set-Top for Channel
Numbers
To specify the minimum number of digits to display on the LED of the set-top for
channel numbers, complete the following steps.
1.
On the DNCS Administrative Console, select the Server Applications tab.
2.
Click DHCT Config.
Result: The DHCT Configure Prompt window opens.
Result: The DHCT Configure Prompt window opens.
3.
Select Global.
Result: The Set Up Global DHCT Configuration window opens.
Result: The Set Up Global DHCT Configuration window opens.
4.
Select the Base Application tab.
Result: The Base Application tab appears in the forefront.
Result: The Base Application tab appears in the forefront.
5.
In the Number of LED Digits field, enter the minimum number of digits to
display on the LED of the set-top for channels. The values are 2, 3, and 4.
6.
Click Save.
Result: The LED on the set-top will display the minimum number of digits
Result: The LED on the set-top will display the minimum number of digits
for channels that you specified in step 5.
7.
Click Cancel.
Result: The DHCT Configure prompt opens.
Result: The DHCT Configure prompt opens.
8.
Click File and Close to close the DHCT Configure prompt.