Cisco Headend Digital Broadband Delivery System 사용자 가이드
4002178 Rev C
Interactive Program Guide Options
6-11
Specify How the Numeric Keys Respond on the Interactive Program Guide
Introduction
The Numeric Key Response option lets you specify what happens when a subscriber
presses a numeric key on the remote control while the Interactive Program Guide is
displayed.
How Do the Numeric Keys Respond?
When the subscriber presses the numeric keys on the remote control while the
Interactive Program Guide is displayed, the keys can respond as follows:
•
•
The guide disappears and tunes to the current channel.
•
The guide changes to Time View (if not already in Time View) and highlights the
channel selected. For example, suppose the guide is in Title View. If the subscriber
presses 2 and 7 on the remote control, the Interactive Program Guide switches to
Time View and highlights the programming for channel 27.
Notes:
•
•
If subscribers do not enter the full channel number, they must press Select to tune
to the channel. For more information, see Specify the Minimum Number of
Digits Required to Change Channels on the Set-Top in Chapter 3.
•
If the system is configured to support channel changing for the scaled video and
the Numeric Key Response option is set to Time View, pressing a numeric key
causes the scaled video to change to the channel number you entered. For more
information, see Allow Subscribers to Change Channels for the Scaled Video,
later in this guide.
Recommended Setting
Select the Switch to Time View, highlight channel option. When subscribers press a
numeric key, the guide changes to Time View (if not already in Time View) and
highlights the channel that was entered.
Specifying How the Numeric Keys Respond on the Interactive Program Guide
To specify how the numeric keys respond on the Interactive Program Guide,
complete the following steps.
1.
On the DNCS Administrative Console, select the Server Applications tab.
2.
Click DHCT Config.
Result: The DHCT Configure Prompt window opens.
Result: The DHCT Configure Prompt window opens.
3.
Select Global.
Result: The Set Up Global DHCT Configuration window opens.
Result: The Set Up Global DHCT Configuration window opens.
4.
Select the IPG tab.
Result: The IPG tab appears in the forefront.
Result: The IPG tab appears in the forefront.