Cisco Headend System Release 2.5 관리 매뉴얼
Chapter 2 Optimize Your System Performance for Downloads and Staging
46
4024836 Rev D
Turn Off Inband SI
System information (SI) is tuning data sent to CableCARD modules. The default
configuration in the DNCS is to send SI as both inband and out-of-band data. This
configuration is due to the way in which previous versions of DHCT software
operated, and it has not been a requirement in recent years. At this time, we
recommend that sites only send SI out-of-band. This helps stabilize the CableCARD
download environment.
Note: Refer to Recommendation for Setting System Information to Out-of-Band (part
Note: Refer to Recommendation for Setting System Information to Out-of-Band (part
number 738143) for procedures to turn off inband SI.
Configuring a Default Download Image
We recommend having the same image on all of your deployed CableCARD
modules and downloading that same image onto both new and factory repaired
CableCARD modules. This recommendation creates a consistent environment for all
cards in your system.
Using group-based downloads will limit which cards use a particular version of
Using group-based downloads will limit which cards use a particular version of
code. For this reason, if you choose to implement group-based downloads, we
recommend configuring a download that sends the most current CableCARD
software (for example, CableCARD software release 1.1.x) to the default CableCARD
group.
Important: If you are running CableCARD software that precedes software release
Important: If you are running CableCARD software that precedes software release
1.1 and you are using an OSM download method, do not send any download-related
UN-Config messages to the CableCARD hardware type list. For details, see Avoid
Sending Download-related UN-Config Messages.
Sending the most current CableCARD software to the default group achieves the
Sending the most current CableCARD software to the default group achieves the
following results:
Eliminates the need to use CVT groups for CableCARD downloads
Provides a standard release with the most recent version of code on all
CableCARD modules