Cisco Model 6109 6 MHz Off-Air Reference (NTSC) 설치 가이드
Chapter 4 Operation
292
4039132 Rev B
USRM Startup Procedure
Follow these steps to start up and run the USRM.
1 Make sure that you have completed the initial setup procedure in the previous
1 Make sure that you have completed the initial setup procedure in the previous
section.
2 Log in to the USRM as user "root" using the default password "generic".
3 Type the following command at the system prompt and press Enter:
3 Type the following command at the system prompt and press Enter:
cd /opt/usrm
Note: Be sure to include the spaces in the command.
4 Type the following command at the system prompt and press Enter:
./usrm [command options]
where [command options] is replaced by the available command line option(s).
Refer to USRM Startup Command Options (on page 286) for a command option
list.
Result: The USRM starts up, and text similar to the following displays:
Refer to USRM Startup Command Options (on page 286) for a command option
list.
Result: The USRM starts up, and text similar to the following displays:
Application startup
Web server startup
CLI startup
SNMP agent startup
Status monitor startup
Status monitor active
Enter User ID:
5 Type a user ID and press Enter:
Note: The default user IDs are "user" and "admin". The "user" access level is used
for normal operation of the server. The "admin" access level is used to modify the
configuration of the server, typically during the installation process.
Result: The following prompt displays:
for normal operation of the server. The "admin" access level is used to modify the
configuration of the server, typically during the installation process.
Result: The following prompt displays:
Enter Password:
6 Type the user's password and press Enter:
Note: The default password for user is "user". The default password for admin is
"admin". These passwords can be changed using the command line interface
(CLI). See Start the Server in Supervised Mode (on page 407) for details.
Result: The USRM application is running and the following prompt displays:
"admin". These passwords can be changed using the command line interface
(CLI). See Start the Server in Supervised Mode (on page 407) for details.
Result: The USRM application is running and the following prompt displays:
USRM-Pri:
or
USRM-Sec: