Cisco DNCS System Release 2.7 3.7 4.2 기술 참조
10
4011319 Rev C
Configure Unencrypted Transport Streams
feature support enabled on your system.
14 For Distribution, select either Default or Hub. If you select Hub, you must select
the appropriate hub from the drop-down list.
Notes:
Select Default if this source is transported to all hubs using a single clear
QAM.
QAM.
Select Hub if this source is only transported to certain hubs. Any hubs that
do not have a hub-specific source defined will use the default source
definition.
do not have a hub-specific source defined will use the default source
definition.
15 Click in the MPEG Program Number field and enter the MPEG program
number being fed into the transport stream. This number must match the
program number of the MPEG source as defined by your content provider.
program number of the MPEG source as defined by your content provider.
16 Click in the Channel Center Frequency field and type the frequency of the
channel you will use to send data from this modulator to the hubs on your
system. You can enter a value in 6 MHz increments from 91 MHz to 867 MHz.
system. You can enter a value in 6 MHz increments from 91 MHz to 867 MHz.
17 Click the Modulation Type arrow, and select ITU J.83 Annex B (6 MHz).
Note: North American sites use the ITU J.83 Annex B (6 MHz) modulation
standard.
standard.
18 Click the Modulation arrow and select the modulation method to be used.
19 Click Save. The system closes the Set Up Non-Cisco Digital Source Definition
19 Click Save. The system closes the Set Up Non-Cisco Digital Source Definition
window and the Source Definition List window updates to include the new
non-Cisco digital source.
non-Cisco digital source.