Cisco Cisco 1 GHz GainMaker Amplifier 설치 가이드
Installing Accessories
31
If you are installing a ...
This will ...
Jumper
activate only one auxiliary port.
Splitter
activate both auxiliary ports with equal
signal levels.
signal levels.
8 dB Coupler or 12 dB Coupler
activate both auxiliary ports with differing
signal levels.
signal levels.
3 Install the signal director in the signal director slot. Refer to the illustration below.
Important: Be sure that the signal director is oriented in the proper direction for
your system. Rotating the signal director in the slot will change which ports are
activated by which signal. Refer to the following table to determine the orientation
appropriate for your system installation.
Note: Be sure that all pins on the signal director bottom align with the pin holes in
the signal director slot, allowing the signal director to install flat against the
amplifier module.
Jumper
your system. Rotating the signal director in the slot will change which ports are
activated by which signal. Refer to the following table to determine the orientation
appropriate for your system installation.
Note: Be sure that all pins on the signal director bottom align with the pin holes in
the signal director slot, allowing the signal director to install flat against the
amplifier module.
Jumper
To activate the ...
Orient the jumper ...
Aux 1 port
so that the word "Thru" on the jumper label
is next to the word "AUX 1" on the amplifier
module cover.
is next to the word "AUX 1" on the amplifier
module cover.
Aux 2 port
so that the word "Thru" on the jumper label
is next to the word "AUX 2" on the amplifier
module cover.
is next to the word "AUX 2" on the amplifier
module cover.
Splitter