Cisco Cisco 1 GHz GainMaker Amplifier 설치 가이드
14
GainMaker Amplifier Reverse Switch Removal Instruction Sheet
748052 Rev C
Line Extender Reverse Switch Removal
Introduction
The steps required to remove a reverse switch from a line extender vary, depending
on whether or not the line extender is located in the field.
The following is a list of all possible steps:
•
The following is a list of all possible steps:
•
Disconnecting power from the line extender
•
Removing the amplifier module from the housing
•
Removing the reverse switch
•
Repositioning the amplifier module in the housing
•
Reconnecting power to the line extender
•
Closing the line extender housing
•
Re-boxing the line extender
Required Tools and Equipment
Before you start, make sure you have the following tools and equipment:
•
•
One two-pin jumper, S-A part number 81630 (provided with these instructions)
•
Torque wrench with a 1/2-in. socket
•
Flat-head screwdriver
•
Screwdriver appropriate for the type of screws on the amplifier module cover
−
−
Phillips-head screwdriver
−
T-15 Torx bit screwdriver
•
Two product labels (provided with these instructions)
−
−
3”x 1” amplifier chassis label
−
3”x 2” box label (for line extenders not located in the field)