Cisco Cisco OptoStar II Driver Amplifier 설치 가이드
Operating using ICIM LCD, Continued
Sub-Menu 5 -- Optical Attenuation/Pump ON/OFF
The illustration below shows sub-menu 5 of the OptoStar II 1550 nm optical
amplifier module - Optical Attenuation/Pump ON/OFF.
amplifier module - Optical Attenuation/Pump ON/OFF.
The default setting of Pump ON/OFF is: ON. The cursor stays on “Set” by default.
The default factory setting of optical attenuation value is 0 dB.
The default factory setting of optical attenuation value is 0 dB.
•
To change current pump status
1. Press ▲▼ buttons to select pump switch (ON or OFF), and the cursor
always stays on “Set”;
2. Press SET button to save the configuration.
•
To select optical attenuation value (with the attenuation range of -3 dB to 0 dB,
with 0.2 dB step)
with 0.2 dB step)
1. Press ► button to move the cursor to the value field on the right side;
2. Press SET button to start the configuration;
3. Press ▲▼ buttons to change the value, and press SET button to confirm;
4. Press ► button to move the cursor to “Set” on the right side of the screen;
5. Press SET button to save the configuration.
2. Press SET button to start the configuration;
3. Press ▲▼ buttons to change the value, and press SET button to confirm;
4. Press ► button to move the cursor to “Set” on the right side of the screen;
5. Press SET button to save the configuration.
Continued on next page
OL-29666-02
Operation
3-11