Cisco Cisco OptoStar II Driver Amplifier 설치 가이드

다운로드
페이지 77
Care and Cleaning of Optical Connectors, Continued 
To Clean Optical Connector 
  Warning: 
Avoid personal injury. Use of controls, adjustments, or procedures other than 
those specified herein may result in hazardous radiation exposure. 
Avoid personal injury. The laser light source on this module or the fiber 
cables connected to this module emits invisible laser radiation. 
Avoid personal injury. Viewing the laser output or fiber cable with optical 
instruments (such as eye loupes, magnifiers, or microscopes) may pose an eye 
hazard. 
 
Do not apply power to this equipment if the fiber is unmated or unterminated.   
 
Do not stare into an unmated fiber or at any mirror-like surface that could 
reflect light emitted from an unterminated fiber.   
 
Do not view the fiber in use with optical instruments (such as eye loupes, 
magnifiers, or microscopes).   
 
Use safety-approved fiber cable to maintain compliance with applicable laser 
safety requirements.   
Important: Ensure that no optical power is present prior to this procedure. 
1. 
Turn optical power off from the connector. 
 
2. 
Inspect the connector for scratches, burns, or other signs of damage using an 
optical connector scope. 
 
Note: If the connector is damaged, replace the jumper. 
 
3. 
If the connector requires cleaning, swipe it across the surface of appropriate 
ferrule cleaner several times. 
 
Result: This will remove dust and some films. 
Note: You may hear a slight "squeak" while cleaning the connector, 
indicating that it is clean. 
4. 
Inspect the connector again. If the connector requires further cleaning, clean it 
using 99% isopropyl alcohol and a lint-free wipe. 
 
5. 
Swipe the connector across the surface of the appropriate ferrule cleaner 
several more times to remove any film left by the alcohol. 
 
6.  Repeat all the steps above as needed until the connector is clean. 
 
 
 
 
 
 
OL-29668-02 
Installation 
2-9