Cisco Cisco OptoStar II 1550nm EDFA 설치 가이드
Operating using ICIM LCD
This section describes how to use the OptoStar II ICIM LCD to operate the
OptoStar II power supply module.
OptoStar II power supply module.
Start
1. Make sure that the power cable on the rear panel of the OptoStar II power
supply module has been connected.
2. Turn the front panel switch of the power supply module to ON position. The
power supply module will initialize for about 5 seconds, and the ICIM will
load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
The LCD now displays ICIM loading screen as shown below.
load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
The LCD now displays ICIM loading screen as shown below.
3. When the device initialization is complete, remove the ICIM display and
begin operation.
Continued on next page
3-6
Operation
OL-29659-03