Cisco Cisco OptoStar II Driver Amplifier 설치 가이드
Console Software Operation
This section introduces the procedures to operate the OptoStar II Console
software.
software.
Before You Begin
•
One PC
•
Mini-USB data cable
•
OptoStar II Console software installation package
Start
1. Make sure that the fiber and RF cables of relevant modules of the OptoStar II
platform are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and relevant modules will initialize for
about 5 seconds, and the ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
about 5 seconds, and the ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
3. When the device initialization is complete, connect the Mini-USB side of the
USB cable provided with the ICIM to the Mini-USB interface of the ICIM front
panel. The other side of the USB cable should be connected to the USB
interface on the PC. Now the LCD screen shows USB connected, and the
keypads below the LCD screen are temporarily unavailable. The illustration
below shows the connection method.
panel. The other side of the USB cable should be connected to the USB
interface on the PC. Now the LCD screen shows USB connected, and the
keypads below the LCD screen are temporarily unavailable. The illustration
below shows the connection method.
4. Start the OptoStar II console software.
3-2
Operation
OL-29664-05