Cisco Cisco OptoStar II Driver Amplifier 설치 가이드

다운로드
페이지 64
Operating using Console Software 
This section introduces the procedures to use the OptoStar II console to manage 
the OptoStar II RF switch module. 
Before You Begin 
• 
One PC 
• 
Mini-USB data cable 
• 
OptoStar II console software installation package 
System Requirements 
• 
Supported operation system: Windows 7, Windows Vista, Windows Server 
2003, and Windows XP 
• 
Processor: 400 MHz Pentium or equivalent processor (minimum requirement); 
1 GHz Pentium or equivalent processor (recommended) 
• 
Memory: 96 MB (minimum requirement); 256 MB (recommended) 
• 
Hard drive: 500 MB free space required 
• 
Monitor: 800 x 600, 256-color (minimum requirement); 1024 x 768 high color, 
32-bit (recommended) 
Start 
1.  Make sure that the RF cables of the OptoStar II RF switch module have been 
connected. 
 
2.  Turn the front panel switch of the OptoStar II power supply module to ON 
position. The power supply module and the RF switch module will initialize 
for about 5 seconds, and the ICIM will load for about 25 seconds.
 
Note: The system will achieve optimal working condition after one hour’s 
warm-up. 
 
Continued on next page 
 
 
 
3-14 
 
Operation 
OL-29669-02