Cisco Cisco OptoStar II Driver Amplifier 설치 가이드
Operating using ICIM LCD
This section describes how to use the OptoStar II ICIM LCD to operate the
OptoStar II reverse receiver module.
OptoStar II reverse receiver module.
Start
1. Make sure that the fiber and RF cables of the OptoStar II reverse receiver
module are connected.
2. Turn the front panel switch of the OptoStar II power supply module to ON
position. The power supply module and the reverse receiver module will
initialize for about 5 seconds, and the ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
The LCD now displays ICIM loading screen as shown below.
initialize for about 5 seconds, and the ICIM will load for about 25 seconds.
Note: The system will achieve optimal working condition after one hour’s
warm-up.
The LCD now displays ICIM loading screen as shown below.
3. When the device initialization is complete, remove the ICIM display and
begin operation.
Continued on next page
3-4
Operation
OL-29663-03