Cisco Cisco OptoStar II Driver Amplifier 설치 가이드

다운로드
페이지 71
Operating using Console Software, Continued
 
Setup Parameters 
The table below lists the setup parameters of the OptoStar II reverse receiver 
module. 
Setup Parameters  Description 
Factory Default 
Optical Alarm 
Threshold 
Shows/sets optical alarm high 
limit and low limit 
Low limit: - 17.0 dB 
High limit: + 3.0 dB 
Module Alarm 
Enable 
Shows / sets module alarm status 
Alarms of all the four 
modules are enabled 
Test Point 
Shows / sets module test point or 
no test point 
No Test Point 
Alarm ON/OFF 
Shows / sets module alarm status: 
ON/OFF 
Alarm ON/OFF corresponds with 
Module Alarm Enable: for 
example, if only Module 1 and 
Module 2 need to be monitored, 
then select Module 1 and Module 2 
in Module Alarm Enable, and 
Alarm ON/OFF in ON position. 
Alarm status: ON 
Gain Control 
Mode Selection 
for Four Modules 
Shows / sets AGC or MGC gain 
control mode 
AGC mode for all 
four modules (0 dB in 
MGC mode) 
 
 
 
3-22 
 
Operation 
OL-29663-03