Samsung CLX-3175FN CLX-3175FN/XAX 사용자 설명서

25 _Getting started

getting started

This chapter gives you step-by-step instructions for setting up the machine.

This chapter includes:
•

•

•

•

•

•

This section shows the steps to set up the hardware which is explained in 

the Quick Install Guide. Make sure you read Quick Install Guide and 
complete following steps.
1. Select a stable location. 

Select a level, stable place with adequate space for air circulation. Allow 

extra space to open covers and trays. 

The area should be well-ventilated and away from direct sunlight or 
sources of heat, cold, and humidity. Do not set the machine close to the 

edge of your desk or table.

 

Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the 
altitude setting to optimize your printing. See "Altitude adjustment" on 

page 31 for more information.

Place the machine on a flat, stable surface so that there is no incline 
greater than 2 mm (0.08 inch). Otherwise, printing quality may be 

affected.

2. Unpack the machine and check all the enclosed items.

3. Remove the tape holding the machine tightly.
4. Load paper.
5. Make sure that all the cables are connected to the machine. 
6. Turn the machine on. 

When you move the machine, do not tilt or turn it upside down. 

Otherwise, the inside of the machine may be contaminated by toner, 

which can cause damage to the machine or bad print quality.