Cisco Cisco Prime Collaboration Assurance 11.5 백서

 

 

© 2015 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 

Page 6 of 33 

Note:   Hyperthreading must be disabled in the server (basic input/output system [BIOS] level) for better 
performance of Cisco Prime Collaboration. Refer to your hardware documentation for information about disabling 

hyperthreading. 

Please refer to the installation guide at 

 for the requirements. 

Please refer to the installation guide at 

 for details. 

The following browsers are supported: Firefox 17 ESR and 24 ESR and Internet Explorer 9 and 10. 

Download the software from the download site for Cisco Prime Collaboration Provisioning. The software is 

available as OVA files and is available for small, medium, large, and very large deployments. The OVAs contain 

the operating system (Linux) as well, so all you need to do is deploy the OVA on your VMware server. 

If you need the Cisco Prime Collaboration Assurance and Analytics application, you need to download that 

software as well; it is also available as OVA files. 

Please refer to the Quick Start Guide at 

 for the OVA details. 

We recommend that you know the values (beforehand) for the following parameters, because you must specify 

them at the console prompts when configuring the virtual appliance: 

● 

IP address: The IP address of the virtual appliance. 

● 

IP default netmask: The default subnet mask for the IP address. 

● 

IP default gateway: The IP address of the default gateway. 

● 

Default DNS domain: The default Domain Name System (DNS) domain. 

● 

Primary nameserver: The primary name server. You may add the name server. To configure several name 

servers, enter y. 

● 

Primary NTP server [time.nist.gov]: The primary Network Time Protocol (NTP) server. 

To enter a secondary NTP server, enter y at the next prompt. 

● 

Timezone: The time zone set for Cisco Prime Collaboration. When you are prompted to enter the system 

time zone, specify the default time zone: UTC. You can use SSH to change the time zone after you install 

the Cisco Prime Collaboration Assurance or Cisco Prime Collaboration Provisioning server; the time stamp 

that is displayed on the user interface is the server time. You must use the same time zone for the Cisco 

Prime Collaboration Assurance and Cisco Prime Collaboration Provisioning servers in converged mode. For 

a list of supported time zones, please visit: 

. 

● 

Username: Command-line interface (CLI) admin username. The username is admin, by default. However, 

you can specify the username of your choice.