Cisco SA III Type 1A Unbalanced Triple with 40 52 MHz Split (Linear Tilt) 설치 가이드
748051 Rev C
GainMaker Amplifier AGC Module Replacement Installation Instructions
3
System Amplifier AGC Module Replacement
Introduction
The steps required to replace an AGC module in a system amplifier vary, depending
on whether or not the system amplifier is located in the field.
on whether or not the system amplifier is located in the field.
The following is a list of all possible steps:
Disconnecting power from the system amplifier
Removing the amplifier module from the housing
Replacing the AGC module
Repositioning the amplifier module in the housing
Reconnecting power to the system amplifier
Closing the system amplifier housing
Re-boxing the system amplifier
Required Tools and Equipment
Before you start, make sure you have the following tools and equipment:
Replacement AGC module (provided with these instructions)
Torque wrench with a 1/2-in. socket
Flat-head screwdriver
Screwdriver appropriate for the type of screws on the amplifier module cover
Phillips-head screwdriver
T-15 Torx bit screwdriver
Two product labels (provided with these instructions)
3”x 1” amplifier chassis label
3”x 2” box label (for amplifiers not located in the field)
Continued on next page