Cisco Cisco 4G LTE Enhanced High-Speed WAN Interface Cards for Europe
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information.
Page 16 of 63
Profile 1, Packet Session Status = ACTIVE
IP address = 10.176.219.57
Primary DNS address = 198.224.174.135
Secondary DNS address = 198.224.173.135
!Currently, only one active profile is supported and is seen to be functional as
listed above.
listed above.
!<snip>
Network Information
===================
Current Service Status = Normal
Current Service = Packet switched
<SNIP>
Radio Information
=================
Radio power mode = ON
Current RSSI = -73 dBm
!
ROUTER#sh ip nat st
Total active translations: 0 (0 static, 0 dynamic; 0 extended)
Peak translations: 1, occurred 01:23:43 ago
Outside interfaces:
Cellular0/0/0 !>>> outgoing interface after NAT
Inside interfaces:
Vlan18 !>>> incoming LAN interface for traffic to be NAT’ed
Hits: 5 Misses: 0
<snip>
Troubleshooting the Basic Connectivity
When basic connectivity does not work properly, use the debugging capability of Cisco IOS Software. Various
debug commands can be used to determine the root cause of the problem and how to fix it. The most common
causes are typos in the configuration.
●
The dialer string, chat-script name, and dialer script name must match in all three places.
●
Make sure that the IP route is configured.
●
Make sure that the NAT access list and NAT statement are properly configured.
●
Make sure that the basic configuration is in place, please refer to section 5.1.
The show cellular x/x/x all command is used to make sure that basic parameters such as RSSI, service, and SIM
are showing correctly.