Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch 관리 매뉴얼

WPS Setup

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE

105

Any one VAP on the WAP device can be enabled for WPS. At most, one WPS 
transaction (for example, enrollment and association of an 802.11 client) can be in 
progress at a time on the WAP device. The WAP device administrator can 
terminate the transaction in progress from the web-based configuration utility. The 
configuration of the VAP, however, should not be changed during the transaction; 
nor should the VAP be changed during the authentication process. This restriction 
is recommended but not enforced on the WAP device.

Although WAP devices support WPS version 2.0, the WAP device interoperates 
with enrollees and registrars that are certified by the Wi-Fi Alliance to conform to 
version 1.0 of the WPS protocol. 

You can use the WPS Setup page to enable the WAP device as a WPS-capable 
device and configure basic settings. When you are ready to use the feature to 
enroll a new device or add the WAP device to a WPS-enabled network, use the 

For security reasons, it is recommended, but not required, that you use an HTTPS 
connection to the web-based configuration utility when configuring WPS.

To configure the WAP device as a WPS-capable device:

Select Wireless > WPS Setup in the navigation pane.

The WPS Setup page shows global parameters and status, and parameters and 
status of the WPS instance. An instance is an implementation of WPS that is 
associated with a VAP on the network. The WAP device supports one instance 
only.

Configure the global parameters:

•

Supported WPS Version—The WPS protocol version that the WAP device 
supports.