Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch 관리 매뉴얼

다운로드
페이지 179
Single Point Setup
Channel Management
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
170
10
Proposed Channel Assignments Table
The Proposed Channel Assignments table shows the proposed channels that are 
to be assigned to each WAP device when the next update occurs. Locked 
channels are not reassigned—the optimization of channel distribution among 
devices takes into account that locked devices must remain on their current 
channels. WAP devices that are not locked may be assigned to different channels 
than they were previously using, depending on the results of the plan.
For each WAP device in the Single Point Setup, the Proposed Channel 
Assignments table shows the location, IP Address, and Wireless Radio, as in the 
Current Channel Assignations table. It also shows the Proposed Channel, which is 
the radio channel to which this WAP device would be reassigned if the channel 
plan is applied.
Configuring Advanced Settings
The Advanced settings area enables you to customize and schedule the channel 
plan for the Single Point Setup. 
By default, channels are automatically reassigned once every hour, but only if 
interference can be reduced by 25 percent or more. Channels are reassigned 
even if the network is busy. The default settings are designed to satisfy most 
scenarios where you would need to implement channel management.
You can change the Advanced settings to configure the following settings:
Change channels if interference is reduced by at least—The minimum 
percentage of interference reduction a proposed plan must achieve in 
order to be applied. The default is 75 percent. Use the drop-down menu to 
choose percentages ranging from 5 percent to 75 percent. Using this 
setting lets you set a threshold gain in efficiency for channel reassignment 
so that the network is not continually disrupted for minimal gains in 
efficiency.
For example, if channel interference must be reduced by 75 percent and 
the proposed channel assignments will only reduce interference by 30 
percent, then channels will not be reassigned. However, if you reset the 
minimal channel interference benefit to 25 percent and click Save, the 
proposed channel plan will be implemented and channels will be 
reassigned as needed.
Determine if there is better set of channels every—The schedule for 
automated updates. A range of intervals is provided, from 30 minutes to six 
months