Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch 관리 매뉴얼
Wireless
Radio
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
63
5
STEP 1
Select Wireless > Radio in the navigation pane.
STEP 2
In the Global Settings area, configure the TSPEC Violation Interval, which is the
time interval in seconds for the WAP device to report associated clients that do
not adhere to mandatory admission control procedures. The reporting occurs
through the system log and SNMP traps. Enter a time from 0 to 900 seconds. The
default is 300 seconds.
time interval in seconds for the WAP device to report associated clients that do
not adhere to mandatory admission control procedures. The reporting occurs
through the system log and SNMP traps. Enter a time from 0 to 900 seconds. The
default is 300 seconds.
STEP 3
In the Basic Settings area, configure these settings:
NOTE
Local regulations may prohibit the use of certain radio modes. Not all
modes are available in all countries.
•
Radio—Turns on or off the radio interface. By default, the radio is off.
•
MAC Address—The Media Access Control (MAC) address for the interface.
The MAC address is assigned by the manufacturer and cannot be changed.
The MAC address is assigned by the manufacturer and cannot be changed.
•
Mode—The IEEE 802.11 standard and frequency the radio uses. Select one
of the available modes:
of the available modes:
-
802.11a—Only 802.11a clients can connect to the WAP device.
-
802.11b/g—802.11b and 802.11g clients can connect to the WAP device.
-
802.11a/n—802.11a clients and 802.11n clients operating in the 5-GHz
frequency can connect to the WAP device.
frequency can connect to the WAP device.
-
802.11b/g/n (default)—802.11b, 802.11g, and 802.11n clients operating in
the 2.4-GHz frequency can connect to the WAP device.
the 2.4-GHz frequency can connect to the WAP device.
-
5 GHz 802.11n—Only 802.11n clients operating in the 5-GHz frequency
can connect to the WAP device.
can connect to the WAP device.
-
2.4 GHz 802.11n—Only 802.11n clients operating in the 2.4-GHz
frequency can connect to the WAP device.
frequency can connect to the WAP device.
•
Channel Bandwidth—The 802.11n specification allows a coexisting 20/
40 MHz channel in addition to the legacy 20 MHz channel available with
other modes. The 20/40 MHz channel enables higher data rates but leaves
fewer channels available for use by other 2.4 GHz and 5 GHz devices.
40 MHz channel in addition to the legacy 20 MHz channel available with
other modes. The 20/40 MHz channel enables higher data rates but leaves
fewer channels available for use by other 2.4 GHz and 5 GHz devices.
By default, when the radio mode includes 802.11n, the channel bandwidth is
set to 20/40 MHz to enable both channel widths. Set the field to 20 MHz to
restrict the use of the channel bandwidth to a 20 MHz channel.
set to 20/40 MHz to enable both channel widths. Set the field to 20 MHz to
restrict the use of the channel bandwidth to a 20 MHz channel.