Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch 관리 매뉴얼

WDS Bridge

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE

92

Personal mode, the WAP device uses WPA2-PSK with CCMP (AES) 
encryption over the WDS link. See WEP on WDS Links or WPA/PSK on 
WDS Links following this procedure for more information about encryption 
options.

Repeat these steps for up to three additional WDS interfaces.

Click Save. The changes are saved to the Startup Configuration. 

Replicate this procedure on the other device or devices connecting to the bridge.

You can verify that the bridge link is up by going to the Status and Statistics 
> Network Interface page. In the Interface Status table, the WLAN0:WDS(x) 
status should state Up.

After new settings are saved, the corresponding processes may be stopped and 
restarted. When this happens, the WAP device may lose connectivity. We 
recommend that you change WAP device settings when a loss of connectivity will 
least affect your wireless clients. 

These additional fields appear when you select WEP as the encryption type.

•

Key Length—If WEP is enabled, specify the length of the WEP key as 
64 bits or 128 bits.

•

Key Type—If WEP is enabled, specify the WEP key type: ASCII or Hex.

•

WEP Key—If you selected ASCII, enter any combination of 0 to 9, a to z, 
and A to Z. If you selected Hex, enter hexadecimal digits (any combination 
of 0 to 9 and a to f or A to F). These are the RC4 encryption keys shared with 
the stations using the WAP device. 

Note that the required number of characters is indicated to the right of the 
field and changes based on your selections in the Key Type and Key 
Length fields.

These additional fields appear when you select WPA/PSK as the encryption type.