Cisco Cisco Web Security Appliance S170 사용자 가이드
3-14
AsyncOS 9.2 for Cisco Web Security Appliances User Guide
Chapter 3 Connect, Install, and Configure
System Setup Wizard
Network / Routes for Management and Data Traffic
Note
If you enable “Use M1 port for management only”, this section will have separate sections for
management and data traffic; otherwise one joint section will be shown.
management and data traffic; otherwise one joint section will be shown.
Network / Transparent Connection Settings
Note
By default, the Cloud Connector is deployed in transparent mode. which requires a connection
to a Layer-4 switch, or a version 2 WCCP router.
to a Layer-4 switch, or a version 2 WCCP router.
Setting
Description
Ethernet Port
(Optional) Check Use M1 port for management only if you want to use a separate
port for data traffic.
port for data traffic.
If you configure the M1 interface for management traffic only, you must configure
the P1 interface for data traffic. You must also define different routes for
management and data traffic. However, you can configure the P1 interface even
when the M1 interface is used for both management and data traffic.
the P1 interface for data traffic. You must also define different routes for
management and data traffic. However, you can configure the P1 interface even
when the M1 interface is used for both management and data traffic.
You can enable and configure the P1 port only in the System Setup Wizard. If
you want to enable the P2 interface, you must do this after finishing the System
Setup Wizard.
you want to enable the P2 interface, you must do this after finishing the System
Setup Wizard.
IP Address /
Netmask
Netmask
The IP address and network mask to use when managing the Web Security appliance
on this network interface.
on this network interface.
Hostname
The host name to use when managing the Web Security appliance on this
network interface.
network interface.
Property
Description
Default Gateway
The default gateway IP address to use for the traffic through the Management and
Data interfaces.
Data interfaces.
Static Routes
Table
Table
Optional static routes for management and data traffic. Multiple routes can be added.
•
Name – A name used to identify the static route.
•
Internal Network – The IPv4 address for this route’s destination on the network.
•
Internal Gateway – The gateway IPv4 address for this route. A route gateway
must reside on the same subnet as the Management or Data interface on which
it is configured.
must reside on the same subnet as the Management or Data interface on which
it is configured.