Cisco Cisco ASA 5580 Adaptive Security Appliance 문제 해결 가이드

Contributed by Ishwinder Cheema and Jay Johnston, Cisco TAC
Engineers.
Jul 31, 2013

Introduction
Prerequisites
     Requirements
     Components Used
Troubleshooting Methodology
     ASA Configuration
        ASDM Image in Flash
        ASDM Image in Use
        HTTP Server Restrictions
        Other Possible Configuration Issues
     Network Connectivity
     Application Software
Run Commands with HTTPS
Related Information

This document provides the troubleshooting methodology necessary to examine issues faced when you
access/configure the Cisco Adaptive Security Appliance (ASA) with Cisco Adaptive Security Device
Manager (ASDM). ASDM delivers security management and monitoring services for security appliances
through a graphical management interface.

The scenarios, symptoms, and steps listed in this document are written for troubleshooting issues after the
initial configuration is set up on the ASA. For the initial configuration, refer to the Configuring ASDM
Access for Appliances section of the Cisco ASA Series General Operations ASDM Configuration Guide, 7.1.

This document uses the ASA CLI for troubleshooting, which requires Secure Shell (SSH)/Telnet/Console
access to the ASA.

The information in this document is based on the ASDM and ASA.

The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure