Cisco Cisco ASA 5515-X Adaptive Security Appliance - No Payload Encryption 문제 해결 가이드
ASA Security Appliance Disk0 Error Message
Document ID: 81884
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Problem
Solutions
Solution 1
Solution 2
Related Information
Prerequisites
Requirements
Components Used
Conventions
Problem
Solutions
Solution 1
Solution 2
Related Information
Introduction
This document describes the Cisco Adaptive Security Appliance (ASA) disk0 error message with resolutions
for the problem.
for the problem.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on the Cisco 5500 Adaptive Security Appliance (ASA) with
software version 7.x.
software version 7.x.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Problem
The disk0 directory displays this error message:
ASA(config)#dir disk0:
Directory of disk0:/%Error calling getdents for disk0:/ (File not found in Inode table)
255426560 bytes total (227303424 bytes free)
When the wr mem command is issued, this error appears: