Cisco Cisco WAP321 Wireless-N Access Point with Single Point Setup 관리 매뉴얼

Single Point Setup Overview

Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE

158

Single Point Setup creates a dynamic, configuration-aware cluster, or group, of 
WAP devices in the same subnet of a network. A cluster supports only a group of 
configured WAP121 devices or a group of configured WAP321 devices. A single 
cluster does not support a mix of WAP121 and WAP321 devices in the same 
group. 

Single Point Setup allows the management of more than one cluster in the same 
subnet or network; however, they are managed as single independent entities. 
The table below shows Single Point Setup wireless service limits. 

A cluster can propagate configuration information, such as VAP settings, QoS 
queue parameters, and radio parameters. When you configure Single Point Setup 
on a device, settings from that device (whether they are manually set or set by 
default) are propagated to other devices as they join the cluster. To form a cluster, 
make sure the following prerequisites or conditions are met:

Plan your Single Point Setup cluster. Be sure the two or more WAP devices you 
want to cluster are the same model. For example, Cisco WAP121 devices can only 
cluster with other Cisco WAP121 devices.

It is strongly recommended to run the latest firmware version on all clustered WAP 
devices. 

Firmware upgrades are not propagated to all WAP devices in a 

cluster; you must upgrade each device independently.

Set up the WAP devices that will be clustered on the same IP subnet and verify 
that they are interconnected and accessible across the switched LAN network.

Enable Single Point Setup on all WAP devices. See 

.

Verify that the WAP devices all reference the same Single Point Setup name. See 

4

40

64

8

160

256