Brother NX-250 작동 가이드
32
GETTING READY
— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
Replacing the needle
Replace the needle as described below. Use the
screwdriver and a needle that has been determined
to be straight according to the instructions in
“Checking the needle”.
screwdriver and a needle that has been determined
to be straight according to the instructions in
“Checking the needle”.
1
Press
(“Needle Position” button) once
or twice to raise the needle.
1 “Needle Position” button
2
Turn off the sewing machine.
3
Place fabric or paper under the presser foot to
cover the hole in the needle plate.
cover the hole in the needle plate.
Note
● Before replacing the needle, cover the hole
in the needle plate with fabric or paper to
prevent the needle from falling into the
machine.
prevent the needle from falling into the
machine.
4
Lower the presser foot lever.
1 Presser foot lever
5
Hold the needle with your left hand, and then
use a screwdriver to turn the needle clamp
screw toward you (counterclockwise) to
remove the needle.
use a screwdriver to turn the needle clamp
screw toward you (counterclockwise) to
remove the needle.
• Do not apply a strong force when loosening
or tightening the needle clamp screw,
otherwise certain parts of the sewing
machine may be damaged.
otherwise certain parts of the sewing
machine may be damaged.
6
With the flat side of the needle toward the
rear of the machine, insert the needle until it
touches the needle stopper.
rear of the machine, insert the needle until it
touches the needle stopper.
7
While holding the needle with your left hand,
use the screwdriver to tighten the needle
clamp screw.
use the screwdriver to tighten the needle
clamp screw.
Install the twin needle in the same way.
●
Before replacing the needle, be sure to
turn off the sewing machine, otherwise
injuries may occur if
turn off the sewing machine, otherwise
injuries may occur if
(“Start/Stop”
button) is accidentally pressed and the
machine starts sewing.
machine starts sewing.
1
CAUTION
1
1 Screwdriver
2 Needle clamp
2 Needle clamp
screw
1 Needle stopper
●
Be sure to insert the needle until it
touches the needle stopper and securely
tighten the needle clamp screw with the
screwdriver, otherwise the needle may
break or damage may result.
touches the needle stopper and securely
tighten the needle clamp screw with the
screwdriver, otherwise the needle may
break or damage may result.
2
1
1
CAUTION