Brother CM550DX/ CM550 작동 가이드
48
Memo
•
In “Direct Cut” mode, the optional 12" × 24"
(305 mm × 610 mm) mat and scanning mat
cannot be used.
(305 mm × 610 mm) mat and scanning mat
cannot be used.
•
Before attaching the material to the mat, use a
corner of the adhesive side of the mat to test
attaching it.
corner of the adhesive side of the mat to test
attaching it.
d
While holding the mat level and lightly
inserting it under the feed rollers on the left and
inserting it under the feed rollers on the left and
right sides of the feed slot, press
in the
operation panel.
• For details, see “Loading the Mat” on page 20.
X
The “Start/Stop” button in the operation panel
lights up.
lights up.
e
Press the “Start/Stop” button to start scanning.
X
When scanning is finished, the scanned image
appears in the screen.
appears in the screen.
f
Check the scanned image, and then touch the
“OK” key.
“OK” key.
■ Editing Cutting Lines
a
In the image trim screen, use the touch pen to
touch
and drag it around the screen to trim
the image.
b
To cut around the image for the pattern, touch
the “OK” key.
the “OK” key.
• Touch
to cut any of a variety of shapes as a
frame around the scanned image. For details on
selecting a frame, see “Advanced Cutting
Functions” on page 49.
selecting a frame, see “Advanced Cutting
Functions” on page 49.
■ Cutting
a
Touch the “Cut” key.
X
The “Cut” key is highlighted, and the “Start/Stop”
button in the operation panel lights up.
button in the operation panel lights up.
b
Press the “Start/Stop” button to start cutting.
• For details on unloading the mat after cutting,
follow the procedure under “Unloading the Mat”
on page 21.
on page 21.