Samsung RS21HKLMR 사용자 설명서
20_
setting up
Check the amount of water supplied
to the ice tray.
to the ice tray.
1. Lift up the icemaker cover and gently pull out.
2. When you press the Test button for 3 seconds,
2. When you press the Test button for 3 seconds,
the ice cube container is filled with water from
the water supply tap. Check to make sure the
amount of water is correct (see the illustration
below).
If the water level is too low, the ice cubes will be
small. This is a water pressure problem from with
in the main water pipes, not the refrigerator.
the water supply tap. Check to make sure the
amount of water is correct (see the illustration
below).
If the water level is too low, the ice cubes will be
small. This is a water pressure problem from with
in the main water pipes, not the refrigerator.
Ice maker
1
Feeler Arm
2
Test button
Check the water level
Connect the water line to the
refrigerator.
refrigerator.
- Remove the compressor cover of the refrigerator.
- Connect the water line to the valve, as shown in
- Connect the water line to the valve, as shown in
the figure.
- When connected, check if there is any leakage.
If any, repeat the connection.
- Reattach the compressor cover of the refrigerator.
WATER LINE
WATER LINE
INSTRUCTIONS COMPRESSOR
INSTRUCTIONS COMPRESSOR
COVER OF REFRIGERATOR
COVER OF REFRIGERATOR
COVER OF REFRIGERATOR
CONNECTION NUT
CONNECTION NUT
Secure the water line.
- Using clip ”A”, fix the
water line to the wall (the
back of refrigerator).
back of refrigerator).
- When the water line
is secure, make sure
whether the water line
is not excessively bent,
pinched or squashed.
whether the water line
is not excessively bent,
pinched or squashed.
CLIP A
CLIP A
WATER LINE
WATER LINE
Removing any residual matter inside
the water supply line after installing
fi lter.
the water supply line after installing
fi lter.
1. Turn ON the main water supply & turn OFF the
valve to the water supply line.
2. Run water through the dispenser until the water
runs clear (approx. 1L). This will clean the water
supply system and remove air from the lines.
supply system and remove air from the lines.
3. Additional flushing may be required in some
households.
4. Open the refrigerator door and make sure there
are no water leaks coming from the water filter.
A newly installed water fi lter cartridge may
cause water to briefl y spurt from the water
dispenser. This is due to air getting into the
line. It should pose no problem to operation.
cause water to briefl y spurt from the water
dispenser. This is due to air getting into the
line. It should pose no problem to operation.