Samsung ASV12PSBAN 사용자 설명서

Fixing the indoor unit in place

Insulation

Pipes

Perform the following work on the area where gas leak test was done priorly.

After checking for gas leaks in the system, insulate the pipe, hose and cables.

Then place the indoor unit on the installation plate.

1. To avoid condensation problems, wrap foam insulation (as shown in the figure) on

a part without insulation on the end of the pipes.

2. Wind the pipe, assembly cable and drain hose with vinyl tape.
3. Place the bundle (the pipe, assembly cable and drain hose) in the lower part

of the indoor unit carefully so it does not project from the rear of the indoor

unit.

4. Hook the indoor unit to the installation plate and move the unit to the right

and left until it is securely in place.

5. Wrap the rest of the pipe with vinyl tape.
6. Attach the pipe to the wall using clamps (optional).

Installation

plate

Connecting wires

Connecting

pipes

Vinyl tape

Drain hose

• Make sure pipe does not move when you install the indoor unit on

an installation plate.

'X' mm

Rubber leg

' m

Install the outdoor unit in level on a stable base to avoid the generation of noise and

vibration, especially when installing the unit close to a neighbor.

If you install the outdoor unit in a place exposed to strong winds or at a height, fix it to an

appropriate support (wall or ground).

1. Place the outdoor unit as indicated on the top of the unit to let the discharged air

out properly.

2. Fix the outdoor unit in level to an appropriate support using anchor bolts.

3. If the outdoor unit is exposed to strong winds, install shield plates around the

outdoor unit so that the fan can operate correctly.

• Ensure the wall will be able to suspend the weight of rack and

outdoor unit;

• Install the rack close to the column as much as possible;
• Install proper grommet in order to reduce noise and residual

vibration transferred by outdoor unit towards wall.

Outdoor unit installed on the wall by rack

Soft rubber designed to cut off

vibration from rack to wall.

(not supplied with product)

Designed to cut off residual vibration

from outdoor unit to rack.

(not supplied with product)

• Secure the rubber leg to prevent the generation of noise and vibration.

Model



09/12 457

254



18

538

290



24

543

319

Fixing the outdoor unit in place

Brazil_AQV&ASV09P@_IBIM_32441A_E.indd 40

2011-6-18 11:11:51