Samsung HW-J470 사용자 설명서

Samsung may offer updates for the Soundbar's 
system firmware in the future.

If an update is offered, you can update the firmware 
by connecting a USB device with the firmware 
update stored on it to the USB port on your 
Soundbar.

Note that if there are multiple update files, you must 
load them onto the USB device singly and use them 
to update the firmware one file at a time.

Please visit samsung.com or contact the Samsung 
call center to receive more information about 
downloading updates files.

 

● The HW-J470 has a DUAL BOOT function. 

If the firmware fails to update, you can 
update the firmware again 

 

● Insert a USB device containing the 

firmware update into the USB port on the 
main unit.

● Updating firmware may not work properly 

if audio files supported by the Soundbar 
are stored in the USB storage device.

● Do not disconnect the power or remove 

the USB device while updates are being 
applied. The main unit will turn off 
automatically after completing the 
firmware update.

● After the update, all settings are reset to 

their factory default settings. We 
recommend you write down your settings 
so that you can easily reset them after the 
update. 
Note that updating firmware resets 
subwoofer connection too. If connection 
to the subwoofer is not established 
automatically after resetting,  
refer to page 14. 
If the firmware fails to update, we 
recommend formatting the USB device in 
FAT16 and trying again.

● Once the software update is complete, 

turn off the product and then press and 
hold the ( p ) button on the remote 
control for more than 5 seconds. “INIT” 
appears on the display and the unit is 
powered off. The upgrade is complete.

● Do not format the USB device in the NTFS 

format. The Soundbar does not support 
the NTFS file system.

● Depending on the manufacturer, some 

USB devices may not be supported.

HW-J470 ZA ENG-0123.indd   24

2015/3/6   15:23:42