Samsung RF260BEAESP 사용자 설명서

setting up

_13

01 SETTING

INSTALLING THE WATER
DISPENSER LINE

A water dispenser with a ﬁ lter is one of the helpful
features on your new refrigerator. To help promote
better health, the water ﬁ lter removes unwanted
particles from your water. However, it does not
sterilize or destroy microorganisms. You may need
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a
water pressure of 138 ~ 862 kPa is required.
Under normal conditions, a 0.17 L cup can be
ﬁ lled in about 10 seconds.
If the refrigerator is installed in an area with low
water pressure (below 138 kPa), you can install
a booster pump to compensate for the low
pressure.
After you have connected the water line, make
sure the water storage tank inside the refrigerator
is properly ﬁ lled. To do this, press the water
dispenser lever until the water runs from the water
outlet.

Water line installation kits are available at
extra cost from your dealer.
We recommend using a water line
installation kit that contains copper tubing
and 6 mm compression nut.

Connecting to the water supply line

First, shut off the main water supply.

Locate the nearest cold water drinking line and

install the pipe clamp and shut off valve.

Connect the water line installation kit to the

shut off valve.

Connecting the water supply line to
the refrigerator.

There are several items that you need to purchase
to complete this connection.
You may ﬁ nd these items sold as a kit at your local
hardware store.

Use Copper Tubing

Use Plastic Tubing

6 mm copper tubing

•

6 mm

•

compression nut

(1pc)
Ferrule (2pc)

•

6 mm plastic tubing

•

→ Molded end(Bulb)
6 mm

•

compression nut

(1pc)

Pipe clamp

Cold water line

Shut off valve

Pipe clamp

Cold water line

Water line installation kit

DA68-02616B(0.0).indb 13

2012.6.15 7:47:54 PM