Samsung RF260BEAESP 사용자 설명서

10_

 

setting up

REMOVING THE 
REFRIGERATOR DOORS

For some installations you need to remove the 
fridge and freezer drawers so you can move the 
refrigerator to its fi nal location. Do not remove 
the doors/drawer if you don’t need to. If you do 
not need to remove the refrigerator doors, go to 
Adjusting the Level on page 12. If you need to 
remove the doors. continue below.
Before removing the door/drawer, make sure you 
read the following items:

Required Tools (Not provided)

You need the following tools to complete the 
installation of your refrigerator:

Philips 

screwdriver(+)

Flat-blade screw 

driver(-)

Socket wrench 

(10 mm)

Pliers

Allen wrench 

(5 mm)

Disconnect power to the refrigerator before 
removing the door or drawer.

•  Be careful not to drop, damage or 

scratch the door/drawer while removing 
them.

Be careful not to get injured while removing the 

• 

door/drawer.
Reattach the door/drawer properly to avoid: 

• 

Moisture from air leakage.

 

-

 Uneven door alignment.

 

-

Wasting energy due to improper door seal.

 

-

WARNING

Disassemble the refrigerator doors

Be careful not to drop and scratch the 
doors while removing the doors.

 With the door opened

Remove 3 screws holding down the  TOP 

1. 

TABLE  ( 1 ) and turn it with wires connected.

Disconnect two connector ( 

2. 2 

) on the left side 

door. To remove the water coupler from the 
hinge, twist and pull it from the hinge.

Pull and remove the hinge lever ( 

3. 3 ).

Remove the ground screw ( 4 ) attached 
to the upper left door hinges with a philips 
screwdriver (+). Remove the upper left and 
right door hinges ( 5 ).

Lift the door straight up to remove.

4. 

WARNING

2

1

3

4

5

DA68-02616B(0.0).indb   10

DA68-02616B(0.0).indb   10

2012.6.15   7:47:27 PM

2012.6.15   7:47:27 PM