Samsung AR13FVSEDUUN 사용자 설명서
12
Checking the remote controller
Remote controller buttons
• Point the remote controller towards the remote controller receiver of the indoor unit.
• When you properly press the button on the remote controller, you will hear beep sound from the indoor unit and a transmit
• When you properly press the button on the remote controller, you will hear beep sound from the indoor unit and a transmit
indicator(
) appears on the remote controller display.
MAX_XSA_IBIM_DB98-33747A_E.pdf
Before using the functions of the remote controller, you should set the current time. (Refer to p.18)
• When you press [2
nd
F] button, the indicator will be displayed on the remote controller and you can change
the functions on the remote controller as listed below.
d'light Cool Temp/Humi, Auto Clean
Time Set function.
If you select the function under the button while the function of the button is switched by 2
nd
F button,
the 2
nd
F function is canceled.
Remote controller display
On Timer
Set the On Timer on.
Smart Saver
Less energy usage makes your space
cool between the temperature range of
24°C~30 °C.
Auto Clean
Auto clean function – Dry inside of the
indoor unit to get rid of odor.
Fan
(Luminous Button)
such as Auto/Low/Medium/High.
Set/Cancel
C
Wi-Fi
ancel the timer/
mode.
2
nd
F
Switch the function of the button on the
remote controller.
Air swing
automatically up and down.
Air swing
(This function is not available for this model).
Mode
Set one of the 5 operating modes
(see pages 14~15 for instructions).
Quiet
Reduce noise generated from an indoor unit
during operation.
Power
(Luminous Button)
Temp + -
(Luminous Button)
Increase/Decrease the temperature by 1 ˚C.
d'light Cool
Set the
mode on.
Turbo
Operate in auto fan speed to cool quickly.
SPi
Set the SPi
Temp/Humi
• Display the room humidity level and temperature value for 5
seconds on the indoor unit display:
- Hi : High (If the relative humidity is 70 % or higher)
- Sd : Standard (If the relative humidity is lower than 70 %)
- For room temperature will be displayed the value.
- Sd : Standard (If the relative humidity is lower than 70 %)
- For room temperature will be displayed the value.
To silence the beep sound when pressing the button.
Time set
Set the current time
SMART Air conditioner Network.
CAUTION
•
Make sure that the water does not get to the remote controller.