Samsung AQV12KBAN 사용자 설명서

Refer to the following chart if the air conditioner operates abnormally. This may save time and unnecessary expenses.

•  Check power status and then operate the air conditioner again.
•   Plug in or switch on the circuit breaker and then operate the air conditioner again.
•   Check if you have set the Off Timer. Operate the air conditioner again by pressing the

Power button.

•   Check if you have selected Dry/Fan/Turbo/d'light Cool mode. In these modes, desired

temperature is set to auto and you cannot adjust the temperature.

•   Check if the set temperature is higher(during Cool mode)/lower(during Heat mode) than

the current temperature. Press the Temp hr. + or – button on the remote controller to 

change the set temperature.

•   Check if the Full HD filter is blocked by dirt. If there is a lot of dust on the Full HD filter,

cooling(heating) performance may decrease. Clean them frequently.

•   Check if the outdoor unit is covered or installed near the obstacle. Take the cover off and

take the obstacle away.

•   If you want to operate the air conditioner in the sunlight, cover the outdoor unit using

curtains or etc.

•   Check if the air conditioner is operating in De-ice mode.  

When the ice formed in winter or the outdoor temperature is too low, the air conditioner 

operates in De-ice mode automatically. In De-ice mode, indoor fan stops and cool air does 

not come out. 

•   If the doors or windows are open, it may cause bad cooling (heating) performance.  

Close the doors and windows.

•   Check if the air conditioner has just been turned on after stopping cooling or heating

operation. In this case, just a fan will run to protect the outdoor unit compressor.

•   Check if the pipe length is too long. When the pipe length exceeds maximum allowable

pipe length, cooling (heating) performance may decrease.

•   Check if you have selected

 mode. In these modes, and you cannot adjust the 

air flow direction. 

(If the good’ sleep mode is operating in Heat mode, you can adjust the air flow direction)

•   Check if you have selected Auto/Dry/Turbo/

/d'light Cool mode. In these 

mode, fan speed is set to Auto and you cannot adjust the fan speed.

•  Check if your batteries are depleted.
•  Make sure nothing is blocking your remote controller sensor.
•   Check that there are strong lighting apparatus near the air conditioner. Strong light which

comes from fluorescent bulbs or neon signs may interrupt the electric waves.

•   Check if you press the Set/Cancel button on the remote controller after you have set the 

time.

•   Press the Power   button or disconnect the power plug/switch off the auxiliary power 

switch.  

If the indicator is still blinking, contact the service center.

•   Check if the appliance is running in a smoky area. Ventilate the room or operate the air

conditioner in Fan mode for 1~2 hours. (We do not use smelly components in the air 

conditioner.)

•  Clean the Full HD filter if they are dirty. Replace the Deodorizing filter if it is dirty.

AQV09K&Y@@_Jungfrau_IBIM_E_32437A.indd   22

2011-1-17   17:06:56