Samsung RSJ1KERS 사용자 설명서
Removing any residual matter inside the water
supply line after installing filter.
supply line after installing filter.
1. Turn ON the main water supply & turn OFF the valve to the water
supply line.
2. Run water through the dispenser until the water runs clear (approx.
1L). This will clean the water supply system and remove air from the
lines.
lines.
3. Additional flushing may be required in some households.
4. Open the refrigerator door and make sure there are no water leaks
4. Open the refrigerator door and make sure there are no water leaks
coming from the water filter.
A newly installed water filter cartridge may cause water to briefly spurt from
the water dispenser. This is due to air getting into the line. It should pose no
problem to operation.
the water dispenser. This is due to air getting into the line. It should pose no
problem to operation.
Check the amount of water supplied to the ice tray. (Optional)
1. Lift up the icemaker bucket and gently pull out of the freezer.
2. When you press the Test button for 3 seconds, the ice cube container is filled with water from the
2. When you press the Test button for 3 seconds, the ice cube container is filled with water from the
water supply tap after ice tray is twisted. Check to make sure the amount of water is correct(see
the illustration below).
the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from
with in the main water pipes, not the refrigerator.
ice maker
1
feeler arm
test button
Check the water level
0_
setting up