Acer altos r510 mk2 사용자 설명서
61
Installing a Floppy Drive into the Converted Hard
Drive Bay (Backplane Installed)
Drive Bay (Backplane Installed)
The slimline floppy drive conversion kit can only be installed into a
system that is using either the SATA or the SCSI backplane. You will
know if you have one of these backplanes installed if you can install
either hot-swap SATA or hot-swap SCSI drives. The conversion kit must
be installed in the left hard drive bay.
system that is using either the SATA or the SCSI backplane. You will
know if you have one of these backplanes installed if you can install
either hot-swap SATA or hot-swap SCSI drives. The conversion kit must
be installed in the left hard drive bay.
1
Observe the safety and ESD precautions at the beginning of this
book. See
book. See
“Safety Information.”
2
Power down the server and unplug all peripheral devices and the
AC power cable.
AC power cable.
3
Remove the chassis cover. For instructions, see
“Removing the
Chassis Cover.”
4
Remove the front bezel if it is installed. For instructions, see
“Removing and Installing the Front Bezel.”
5
Remove the left hot-swap hard drive carrier from the chassis.
6
Remove the screws that attach the slide rails to the floppy drive
conversion kit carrier.
conversion kit carrier.
7
Slide the floppy drive into the drive carrier, rear of the drive first,
with the underside of the drive facing down.
with the underside of the drive facing down.
8
Line up the holes in the side of the drive with the holes in the
carrier. See letter “A” in the figure below.
carrier. See letter “A” in the figure below.